I Daily inspection and maintenance of the press
Before the main motor is pneumatic: 1. All parts are fully lubricated; 2. Whether the air pressure meets the required pressure; 3. Whether the clutch safety double valve operates abnormally; 4. Check whether the electrical box, button station, operation panel and safety device are normal ;
start up After the main motor is started: 1. Check the flywheel operation status and direction; 2. Check the clutch and brake action; 3. Check other operating specifications.
Inspection of Inspection during operation: 1. Check the braking condition of the brake; 2. Check the reading changes of each instrument; 3. Check whether there is air or oil leakage.
Inspection after shutdown: 1. Each operation button is in the "off" position to turn off the air source; 2. Check whether the bolts are loose; 3. Drain the water from the air filter and the air cylinder. 4. Clean and maintain all parts. 5.Turn off the air source and power
II weekly inspection and maintenance of press
Inspection and maintenance items: 1.Clean the air filter; 2.Check the cam controller; 3.Check the electrical equipment; 4.Check the slider adjustment mechanism; 5.Clean the parts
Check the maintenance content: 1. Clean the metal mesh in the filter. When the filter is blocked, the air pressure will not rise. 2. Check whether the cam controller is loose or the cam plate is misaligned. 3. Check whether the joints of electrical components are loose, and the cables and hoses are not broken or broken to cause short circuit. 4. Operate the slider to move up and down, whether the cables and hoses are broken or broken and cause short circuit. 5. Remove the leaked oil, dust, waste, etc., and check for damage.
III Annual inspection and maintenance of press
Inspection and maintenance items: 1. Accuracy inspection; 2. Disassembly and inspection of clutch and brake; 3. Inspection of solenoid valve; 4. Inspection of basic screws; 5. Inspection of pneumatic system; 6. Oil in oil system and gearbox; 7. Internal inspection of balance cylinder, inspection of gas storage tank
Inspection and maintenance content: 1. Slide guide clearance 0.03mm-0.04mm; 2. Abrasion amount of friction plate, whether there is deformation or scar on friction surface, aging of seal ring, deformation or damage of spring, repair or replace when defective. . 4. Tighten the screws. 5. Check whether there is air leakage and whether the pressure gauge can reset to zero. Inspect the seal ring for aging, scars, and slack in the connection. Replace the internal oil, etc. Drain the oil from the slider. 7. Dismantle the balance cylinder to check whether there is any tooth injury on the inner wall, damage or deformation of the seals, etc., whether the safety valve action of the reservoir tank is sensitive and the interior of the gas tank is clean.